A SERVICE OF

logo

Open as PDF
next previous
17
206-4218
(Continued from previous page)
8. At the
Command >
prompt, type info and press Enter. (You can press Enter at any
OAT100R command prompt to view current menu, if desired.)
The initial System Information display identifies OAT100R default configuration settings,
including the Control Port IP address, the PID conguration, and the output conguration,
for example:
OAT100R
CodePlus Off Air Transcoder System
Copyright (c) 2010-2012 LG Electronics U.S.A, Inc.
Copyright (c) 2010-2012 Zenith Electronics LLC
SN: 201-12301011
Version 2.1
HW id: 12-19
Ctrl MAC: 00:0C:63:3A:FF:EC
Ctrl IP: 10.166.60.92
Program PIDs: 0x30 - 0x6f
Output: RF
RF config: Mode 2, 256-QAM-B, RF: 6 MHz, 5.36 MSps
RF channels: 2 3 4 5
Local time: Tue Jan 8 14:42:02 CDT 2014
9. Check the Ctrl IP (Control Port IP address) eld in the System Information display. By
default, the OAT100R uses DHCP; thus, the DHCP server, if congured, assigns an IP
address to the OAT100R once the OAT100R successfully connects to the network.
• If the Ctrl IP eld shows an IP address, the OAT100R is up and running on the network.
Continue with step 10.
• If the network is congured for DHCP but the Ctrl IP eld is blank, refer to “Network Setup”
troubleshooting information on page 68.
• If the network is not congured for DHCP, you will need to congure a static IP address
for the OAT100R. Complete steps 10 to 13 (as required), and then set the OAT100R IP
address using the commands indicated in step 14.
10. Check the Output eld in the System Information display. If the default value (RF) does not
identify the appropriate output type, set the output mode as follows:
a) At the
Command >
prompt, type setup and press Enter to access the Setup Menu.
b) Use the Setup Menu “omode” command to set the appropriate output mode. See “Set
the Output Mode” on page 49 for further information.
11. The next step depends on the output mode:
• If you are setting up the system for RF output, continue with step 12.
• If you are setting up the system for IP output, go to step 13.
System Setup (Cont.)
(Continued on next page)