53
206-4218
Conguration Options via Command Line (Cont.)
(Continued from previous page)
2. Either:
• Continue with step 3 for information on modifying the IP conguration of the Control Port.
• Go to step 8 for information on modifying the DNS conguration.
• To exit the Network Conguration Menu without modifying any settings, type exit at the
Network Conguration Menu
>
prompt.
3. Type ip and press Enter to modify the conguration of the Control Port.
4. At the
Host name [oat100r]:
prompt, either press Enter to accept the default value in
square brackets, or type a new host name and then press Enter.
5. At the
Using DHCP (Y/N) [Y]:
prompt, type y if the OAT100R uses DHCP, or type n to
specify the network IP addresses. Then, press Enter.
6. If the OAT100R is NOT using DHCP, type the information requested at each of the following
prompts. Press Enter after each entry.
This host IP address []:
(Type the host IP address in the format xxx.xxx.xxx.xxx.)
Network mask []:
(Type the netmask in the format xxx.xxx.xxx.xxx.)
Gateway IP address []:
(Type the IP address of the default gateway in the format xxx.xxx.xxx.xxx.)
7. Once you enter the gateway IP address, the system will redisplay the Network Configuration
Menu.
• To modify the DNS conguration, continue with step 8.
• If no additional network conguration is required, go to step 9.
8. To change the DNS conguration, type dns and press Enter.
At each of the following prompts, type the information requested. Press Enter after each
entry.
Configuring DNS
Primary DNS IP address []:
Secondary DNS IP address []:
Once you enter the secondary DNS IP address, the system will redisplay the Network
Configuration Menu. You can select another option to modify (see previous steps) or you
can exit as described below.
9. When you are nished with network conguration, type exit at the Network Conguration
Menu
>
prompt. The system will display an overview of the new network conguration
and then prompt for conrmation to save the changes, for example:
(Continued on next page)
