A SERVICE OF

logo

64
206-4218
Conguration Options via Command Line (Cont.)
Identify the Site Location
This option enables you to identify the site in which the OAT100R is installed. If specified as
described below or in the GUI System Setup screen, the site location is identified as part of the
System Information display (available from the Main Menu and Setup Menu).
1. At the
Setup Command >
prompt, type location and press Enter.
2. At the
Enter Location Description:
prompt, type a brief description of the location.
Then, press Enter.
The system will prompt for conrmation:
Are you sure you want to set the location description? [y/n]:
3. Either:
• Type y and press Enter to conrm. The system will display conrmation, for example:
Location description has been set.
• Type n and press Enter to return to the Setup Command prompt without specifying a
location.
Exit the Setup Menu
At the
Setup Command >
prompt, type exit and press Enter to exit the Setup Menu and
return to the OAT100R Main Menu
Command >
prompt.
Reset the System
This command is also available from the OAT100R Main Menu.
1. At the
Setup Command >
prompt, type reset and press Enter.
The system will prompt for conrmation:
Are you sure you want to reset the system? [y/n]:
2. Either:
• Type y and press Enter to initiate an immediate reset of the OAT100R. The reset process,
during which each of the tuners will also be reinitialized, may take up to two minutes, after
which the system resumes normal operation.
• Type n and press Enter to return to the Setup Command prompt without resetting the
system.