LG - Life's Good OAT100R Manual

A SERVICE OF

next previous

18

206-4218

(Continued from previous page)

12. (RF output only) Complete OAT100R RF output configuration as follows:

a) If the

Command >

prompt is on display, type setup and press Enter to access the

Setup Menu.

b) Use the Setup Menu “rf” command to congure the RF mode and the RF channels. See

“Configure the RF Output” on page 54 for further information.

c) Connect RF OUT on the OAT100R rear panel to the RF distribution center combiner,

and balance the RF signal so that the signal level at the TV(s) is between 0 to +7 dBmV.

Caution: For proper system performance, the OAT100R signal level at the

TV input (ANTENNA IN) must be between 0 to +7 dBmV. Note that additional

equipment (i.e., attenuators) may be required to adjust the signal level.

d) Go to step 14.

13. (IP output only) Complete OAT100R IP output configuration as follows:

a) If the

Command >

prompt is on display, type setup and press Enter to access the

Setup Menu. Then, at the

Setup Command >

prompt, type ipout and press Enter to

access the IP Output Conguration Menu.

b) The IP Output Conguration Menu offers two options for configuring output IP channels:

• To manually congure the output IP channels, use the “set’’ command. You will need

to specify a multicast IP address and the multicast port number for each tuner.

• To auto-congure output IP channels from a base multicast IP address and port

number, use the “ll” command. Once you enter the base multicast IP address and

the multicast port number, the system will auto-increment the remaining IP channels.

Refer to “Congure the IP Output” on pages 56 to 59 for further information on the IP

Output Conguration Menu commands.

c) (Optional) Use the IP Output Configuration Menu “ttl” command, as necessary, to

set the multicast TTL, i.e., the number of hops allowed before the multicast data is

dropped. If a router is being used on the system, the TTL value should be the number

of router hops + 1. If a router is not being used, leave the TTL set to 1 (default).

Note: The option to set the TTL is available only with OAT100R version 2.0 or later

software.

d) Once you have completed the output IP conguration, make sure to use the IP Output

Conguration Menu “apply” command to conrm and apply the conguration data to

the system. Then, at the next

IP Output Command >

prompt, type exit and press

Enter to return to the Setup Menu prompt.

e) Connect a CAT5E or better cable between the Feature Port on the OAT100R rear

panel and the institution’s IP distribution network.

f) Continue with step 14.

System Setup (Cont.)

(Continued on next page)