ES-2048 User’s Guide
202 Chapter 27 Cluster Management
Figure 101 Clustering Management Configuration
The following table describes the labels in this screen.
Table 66 Clustering Management Configuration
LABEL DESCRIPTION
Clustering Manager
Active Select Active to have this switch become the cluster manager switch. A cluster
can only have one manager. Other (directly connected) switches that are set to
be cluster managers will not be visible in the Clustering Candidates list. If a
switch that was previously a cluster member is later set to become a cluster
manager, then its Status is displayed as Error in the Cluster Management
Status screen and a warning icon ( ) appears in the member summary list
below.
Name Type a name to identify the Clustering Manager. You may use up to 32 printable
characters (spaces are allowed).
VID This is the VLAN ID and is only applicable if the switch is set to 802.1Q VLAN.
All switches must be directly connected and in the same VLAN group to belong
to the same cluster. Switches that are not in the same VLAN group are not visible
in the Clustering Candidates list. This field is ignored if the Clustering
Manager is using Port-based VLAN.
