Filter
Top Products
All other trademarks are the property of their respective
owners.
FCC/IC Notice
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
To maintain compliance with FCC RF exposure
guidelines, if you wear a handset on your body, use the
Kyocera Wireless Corp. (KWC) supplied and approved
case CA90-G2603-01 and universal belt clip
55-B1795-01.
Other accessories used with this device for body-worn
operations must not contain any metallic components and
must provide at least 22.5 mm separation distance
including the antenna and the user’s body.
THIS MODEL PHONE MEETS THE GOVERNMENT’S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and receiver.
It is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission of
the U.S. Government. These limits are part of
comprehensive guidelines and establish permitted levels
of RF energy for the general population. The guidelines
are based on standards that were developed by
independent scientific organizations through periodic and
thorough evaluation of scientific studies. The standards
include a substantial safety margin designed to assure the
safety of all persons, regardless of age and health.
The exposure standard for wireless mobile phones
employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6 W/kg.* Tests for SAR are conducted using standard
operating positions specified by the FCC with the phone
transmitting at its highest certified power level in all tested
frequency bands.
Although the SAR is determined at the highest certified
power level, the actual SAR level of the phone while
operating can be well below the maximum value. This is
because the phone is designed to operate at multiple
power levels so as to use only the power required to reach
the network. In general, the closer you are to a wireless
base station antenna, the lower the power output.
Before a phone model is available for sale to the public,
it must be tested and certified to the FCC that it does not
exceed the limit established by the government-adopted
requirement for safe exposure. The tests are performed in
positions and locations (e.g., at the ear and worn on the
body) as required by the FCC for each model. The highest
SAR values for these model phones are:
FCC ID: OVFKWC-KE433 (Phone Model KE433)
PCS mode - Head: 1.30mW/g; Body-worn: 0.584mW/g.
(Body-worn measurements differ among phone models,
depending upon availability of accessories and FCC
requirements. The body-worn SAR values provided above
were obtained by using Kyocera Wireless Corp. [KWC]
supplied and approved case CA90-G2603-01 and
universal belt clip 55-B1795-01).
While there may be differences between the SAR levels of
various phones and at various positions, they all meet the
government requirement for safe exposure.