Filter
Top Products
15
Charging your phone
Connect the wall adapter and USB cable as 1
shown below. The USB symbol on the USB
cable should face toward you.
Plug the USB cable (as shown below) into 2
the phone's Charger/Accessory Port. Make
sure the USB symbol is facing upwards.
Always unplug the charger from the wall
socket after the phone is fully charged to
save unnecessary power consumption of
the charger.
n
NOTE
The battery must be fully charged initially
to improve battery lifetime.
n
NOTE
Your phone has an internal antenna. Be
careful not to scratch or damage this
rear area, as that will cause loss of
performance.
When the battery becomes fully discharged
and you connect the phone to a charger,
the keypad LED lights at the bottom of the
phone will blink. This is normal operation
for a completely discharged battery to
prevent over-current flowing because the
phone is designed to provide reasonable
protection against damage to the battery.
After a few minutes, the screen will turn on
and display a battery image.
Inserting a microSD card
Insert a microSD™ card to use the camera
and other multimedia features. Multimedia
contents can be saved in the microSD card.
Your has a microSD card
pre-installed.
n
NOTE
This device supports up to a 32GB microSD
card.
Getting Started