Filter
Top Products
Settings
59
Change lock code
When changing the lock code, avoid using codes similar to emergency numbers
such as 911 to prevent accidental dialing of an emergency number.
Note: If you enter the wrong lock code five times in succession, your phone
will either not accept your current lock code for 5 minutes (even if you
switch off the phone between attempts) or will switch off.
To change the phone lock code, do the following:
1. In the standby mode, select Menu > Settings > Security.
2. Enter the current lock code, and select OK.
3. Select Change lock code.
4. Enter the new lock code (only 4 characters), and select OK.
5. Enter the new lock code again for verification, and select OK.
When you change your lock code, make sure to remember it. If necessary, write it
down and store it in a safe place away from your phone.
Call restrictions
Call restrictions allows you to block or permit numbers for incoming or outgoing calls.
1. In the standby mode, select Menu > Settings > Other settings > Security.
2. Enter the lock code, and select OK.
3. Select Call restrictions and the type of calls you wish to restrict:
Restrict outgoing calls—Set restrictions on making calls.
Restrict incoming calls—Set restrictions on receiving calls.
4. Select whether to block or allow numbers:
Blocked numbers—Set numbers that are blocked on incoming calls, allowing
all other numbers. When a number is blocked, the call is sent to voice mail.
Allowed numbers—Set numbers that are allowed, blocking all other numbers.
5. To modify the restriction list, select from the following options:
Select—Add numbers to the restriction list.
Add restriction—Add a restriction to a number (unavailable if memory is full).
Edit—Edit a restriction on a number.
Delete—Delete a number from restriction list.
When calls are restricted, calls may be possible to the official emergency number
programmed into your device.