Filter
Top Products
74
Default profile — to select the profile you want to activate each time you connect
the enhancement to your device
Automatic answer — to set the device to answer an incoming call automatically
after 5 seconds when this enhancement is connected to your device. If the Ringing
type is set to Beep once or Silent, automatic answer cannot be used, and you must
answer the call manually.
Lights — to set the device lights continuously on while using the enhancement,
select On.
Security
Select Phone and SIM card, Certificate management, or Security module.
Phone and SIM card
You can change the following codes: lock code, PIN or UPIN code, and PIN2 code.
These codes can only include the numbers from 0 to 9.
Avoid using access codes similar to emergency numbers to prevent accidental
dialing of the emergency number.
Code in use — to select the active code, PIN or UPIN, for the active USIM. This is
shown only if the active USIM supports UPIN, and the UPIN is not rejected.
PIN code request or UPIN code request — to set the device to request the code
each time the device is switched on. Some SIM cards may not allow the PIN code
request to be turned Off. If you select Code in use > UPIN, UPIN code request is
shown instead.
PIN code or UPIN code, PIN2 code, and Lock code — to change the codes
Keypad autolock period > User defined — to automatically lock the keypad after a
defined period of inactivity
Phone autolock period — to set a time-out after which the device is automatically
locked. To use the device again, you need to enter the correct lock code. To turn off
the autolock period, select None.
Lock if SIM card changed — to set the device to prompt for the lock code when an
unknown, new SIM card is inserted into your device. The device keeps a list of SIM
cards that are recognized as the owner cards.
Closed user group (network service) — to specify a group of people whom you can
call and who can call you. For more information, contact your service provider. To
activate the default group agreed on with the service provider, select Default. If