Filter
Top Products
[ 11 ]
Review the basics
4
2
Plug the charger into a standard AC outlet.
• After a few seconds, the battery indicator in the
display starts to scroll from bottom to top.
• When the battery is 80% full, the bar on in the
display stops scrolling and
Battery full
appears
(if the phone is on).
• Unplug the phone and charger once charging
is complete.
Battery notes
Use the following guidelines to obtain the best performance from
your battery:
• With your phone turned off, charge your new battery for three hours
before its first use. Use the battery until it is fully discharged. Repeat
this procedure twice for a total of three charging cycles.
• Note that a new battery's full performance is achieved only after two
or three complete charge and discharge cycles. Battery operation
time may be less than the estimated times during the first charges.
This condition is normal.
• You can use your phone while the battery is charging. However, if the
battery is completely empty, it may need to recharge a few minutes
before you can make or receive calls or the battery indicator appears.
• After the first charge, you can make and receive calls during the
charging cycle, but the calls interrupt the charge. When the phone
call ends, the charge will resume.
• The bars on the screen stop scrolling and remain constant when the
phone is fully charged. If you leave the phone connected to the charger,
the battery receives an additional charge. If you switch the phone on
when charging is complete, the message
Battery full
momentarily
appears in the display.
Note:
The battery will accept a "trickle charge" for an additional
two hours.