Nokia 6670 Cell Phone User Manual


 
Nokia 6670 User Guide 19 Copyright © 2005 Nokia
Getting started
SWITCH THE PHONE ON OR OFF
Press and hold the Power key.
After it is switched on, the phone goes through
various start-up stages while it is loading software.
It may be more than 30 seconds before the phone
is ready for use.
TIPS ON EFFICIENT OPERATION
Your phone has an internal antenna on the back of the
phone above the camera lens.
Note: As with any other radio transmitting
device, do not touch the antenna unnecessarily
when the device is switched on. Contact with the
antenna affects call quality and may cause the
phone to operate at a higher power level than
otherwise needed. Avoiding contact with the
antenna area when operating the phone optimizes
the antenna performance and the battery life.
IF THE PHONE REQUESTS A PIN CODE
The PIN code is usually supplied with the SIM card.
Key in the code (displayed as ****), and press OK. For more information on
PIN codes, see “Security” on page 72.
IF THE PHONE REQUESTS A LOCK CODE
Key in the lock code (displayed as *****), and press OK. The factory setting for the
lock code is 12345. For more information on security codes, see “Security” on
page 72.
SET THE TIME AND DATE
If you are prompted to enter the time and date when you turn your phone on,
use the number keys 09 to key in the current time, then the date. Press OK to
accept the settings. See also “Date and time” on page 71.
MAKE A CALL
1 In the standby mode, key in the phone number, including the area code.
2 If you make a mistake, press the Clear key to clear numbers.
3 Press the Send key, and wait for the answer.
4 Press the End key to finish the call or cancel the call attempt.