Nokia 8210 Cell Phone User Manual


 
Reference information
Copyright © 2004 Nokia. All rights reserved.
57
You cannot change the PUK code. If
you lose the code, contact your serv-
ice provider.
PUK2 code (8 digit)
The PUK2 code, supplied with some
SIM cards, is required to change a
blocked PIN2 code.
If you key in an incorrect PUK2 code
ten times in succession, you cannot
use the functions requiring the PIN2
code. Contact your service provider
for a new card.
You cannot change the PUK2 code. If
you lose the code, contact your serv-
ice provider.
Barring password
The barring password is needed when
using the ‘Call barring’ function. You
obtain the password from your service
provider.
Ciphering indicator
Depending on the network, the ci-
phering indicator may be dis-
played during a call to notify that call
encryption is off.
For more information, contact your
network operator.
Battery information
Li-Ion battery BLB-2 is the manufac-
turer-approved rechargeable battery
is available for your phone.
Charging and
discharging the battery
Your phone is powered by a re-
chargeable battery.
Never remove or replace the bat-
tery when the phone is connected
to the charger.
Note that a new battery’s full per-
formance is achieved only after
two or three complete charge and
discharge cycles!
The battery can be charged and
discharged hundreds of times but
it will eventually wear out. When
the operating time (talk-time and
stand-by time) is noticeably short-
er than normal, it is time to buy a
new battery.
Use only batteries approved by the
phone manufacturer and recharge
your battery only with the charg-
ers approved by the manufacturer.
When a charger is not in use, dis-
connect it from the power source.
Do not leave the battery connect-
ed to a charger for longer than a
week, since overcharging may
shorten its life. If left unused a ful-
ly charged battery will discharge
itself over time.