Filter
Top Products
Tools
97
Copyright © 2006 Nokia. All rights reserved.
Cell info display—Select On to set the device to indicate
when it is used in a cellular network based on
microcellular network (MCN) technology and to activate
cell info reception.
Enhanc. sett.
In the standby mode, indicates a compatible headset
is connected, and that the headset is unavailable, or
a Bluetooth connection to a headset is lost. indicates
a compatible loopset is connected, that a Text
phone is connected, and that a car kit is connected.
Select Headset, Loopset, Text phone, Bluetooth
handsfree, or Car kit and from the following:
Default profile—Set the profile that you want activated
each time you connect a certain enhancement to your
device. See ‘Profiles—set tones’, p. 78.
Automatic answer—Set if you want the device to answer
an incoming call automatically after 5 seconds. If the
Ringing type is set to Beep once or Silent, automatic
answer is disabled. Automatic answer is not available for
Text phone.
If you are using a Text phone, you must activate it on your
device. Press , and select Tools > Settings >
Enhancement > Text phone > Use text phone > Yes.
Voice commands
You can use voice commands to control your device. For
more information about the enhanced voice commands
supported by your device, see ‘Voice dialing’, p. 50.
To activate enhanced voice commands for starting
applications and profiles, you must open the Voice cm.
application and its Profiles folder. Press , and select
Tools > Voice cm. > Profiles; the device creates voice tags
for the applications and profiles. To use enhanced voice
commands, press and hold in the standby mode, and
say a voice command. The voice command is the name of
the application or profile displayed in the list.
Tip! Alternatively, to define the side key to use voice
commands, see ‘General’, p. 8.
To add more applications to the list, select Options > New
application. To add a second voice command that can be
used to start the application, select Options > Change
command, and enter the new voice command as text.
Avoid very short names, abbreviations, and acronyms.
To listen to the synthesized voice tag, select Options >
Playback.
To change voice command settings, select Options >
Settings. To switch off the synthesizer that plays
recognized voice tags and commands in the selected