Filter
Top Products
Copyright © 2006 Nokia. All rights reserved.
Settings
98
Call
Send my caller ID — Select Yes or No to set your phone
number to be seen by or hidden from the person to whom
you are calling. Otherwise, the value may be set by your
service provider when you make subscribe to the network
service. Set by network is displayed.
Call waiting — If you have activated call waiting (network
service), the network notifies you of a new incoming call
while you have a call in progress. To check whether the
function is active, select Check status. To set the function
on or off, select Activate or Cancel.
Reject call with SMS — Select Yes to send a text message
to a caller informing why you could not answer the call.
See "Answer or reject a call", on page 52.
Message text — Write text to be sent in a text message
when you reject a call.
Image in video call — Select a still image to be displayed
instead of video.
Automatic redial — Select On, and your device makes a
maximum of 10 attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialing,
press .
Summary after call — Activate this setting if you want the
device to briefly display the approximate duration of the
last call.
Speed dialling — Select On, and the numbers assigned to
the speed dialing keys ( — ) can be dialed by pressing
and holding the key. See also "Speed dial a phone number",
on page 47.
Anykey answer — Select On. To answer an incoming call,
briefly press any keypad key, except , , , and
.
Line in use — This setting (network service) is shown only
if the SIM card supports two subscriber numbers, that is,
two phone lines. Select which phone line you want to use
for making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line. If
you select Line 2 and have not subscribed to this network
service, you will not be able to make calls. When line 2 is
selected, is shown in the standby mode.
Tip! To switch between the phone lines, press and
hold in the standby mode.
Line change — To prevent line selection (network service),
select Disable if supported by your SIM card. To change
this setting, you need the PIN2 code.