Filter
Top Products
37
8.
Press the Down key to highlight the Security Type option. Press the Left
or Right key to set to KEY NONE, WEP 64 bit, WEP 128 bit, WPA-PSK, or
WPA2-PSK. The Key field only becomes active if you choose an option
other than None.
Note: The Security Type refers to the particular security protocol being used for a specific wireless network.
WPA is the current security standard for wireless networks and is recommended by T-Mobile. WEP is
an older, and less robust security standard, but it provides wider compatibility.
9. Press the Down key to highlight the Key: option. For information on the key
required, see "Use Get Security Key" on page 34.
10. Press the Down key to highlight Connection Settings. Press the Left or
Right key to set to Automatically Connect, or Don’t automatically
connect.
11. Press the Down key to highlight the Non-Broadcast SSID option. Press
the key to place a checkmark in this box if your router does NOT
broadcast its SSID. In general, the default setting for most routers will
broadcast the SSID.
12. Press the Down key to highlight the Inter AP handovers option.
13. Press the key to place a checkmark in this box if you want your phone
to perform a fast handoff (for quicker authentication).
14. Press the Down key to highlight the IP setting option. Press the Left or
Right key to set to Dynamic or Static. Dynamic is the standard and
recommended setting.
If you select Static in this step, press the Down key to highlight the IP
address option. Press the key to enter the IP address menu. If you are
using a T-Mobile Router, copy the information regarding the Subnet Mask,
DNS Server, and Gateway from your router into your phone. The IP address
you input must be different from the one you use to access the router. If
you are connected to a Wi-Fi network that requires Static IP addresses
(usually in a corporate environment), please see your System Administrator
to get the required information.
15. When finished, press the Save soft key.