Filter
Top Products
Getting Started 9
A blinking empty battery icon ( ) and a tone sounding
indicate you have two to three minutes before the battery is too
low to operate the phone.
If you continue to use your phone without charging its battery, the
phone will shut down.
Activating Your Phone
If necessary, contact your Wireless Carrier and follow their
instructions for obtaining service. We suggest that you read this
manual to fully understand the services your phone supports.
Turning Your Phone On
ᮣ
Press and hold until the display lights.
Note:
As with any other radio-transmitting device, do not touch the antenna
while using your phone as this can affect call quality and can cause the
phone to operate at a higher power level than is necessary.
•
The phone begins searching for a network signal.
•
Once the phone finds a signal, the time, date, and day appear in the
bottom of the display.
•
You’re now ready to place and receive calls.
Note:
If you are outside of your carrier’s coverage or roaming area, the No
Service icon ( ) appears at the top of the phone’s display. If you
cannot place or receive calls, try later when service is available, or at
another location.
Turn Your Phone Off
ᮣ
Press and hold for two or more seconds. Your phone
powers off.
Note:
If your phone is on and you press for less than one second, the
phone will not power off. This prevents your phone from being turned
off accidentally.
Setting Up Your Voicemail
Voicemail allows callers to leave voice messages, which can be
retrieved any time.
Note:
Once your Voicemail account has been set up, you can use the
Voicemail folder (under the Message menu) to view details of voice
messages in your Voicemail box.
1. In standby mode, press and hold the key or enter your
own mobile number and press to dial Voicemail.
2. Follow the prompts in the new user tutorial to setup your
mail box.
Listen to Voicemail
ᮣ
In standby mode, press and hold the key or enter your
own mobile number and press to dial Voicemail. After
connecting, you will hear your voice greeting. You are
prompted to enter your password.