Filter
Top Products
100
Camera
Taking Pictures
Taking pictures with the built-in camera is as simple as choosing a subject, pointing
the lens [located on the outside of the folder (above the external display)], and
pressing a button.
Simple Snap Shot
To take a single picture using the current camera settings, do the following:
1. In standby mode, press the Camera (down navigation) key ( ).
The message “Loading...” followed by a camera viewfinder screen
appears in the display. (See “Camera Screen” on page 101 for more
information.)
Note: You can also activate the camera (from standby mode) by doing one of the following:
- Press the MENU key( ), then press (for Multimedia) and for Camera.
- Press and hold until the phone prompts, “Say a command.” Say “Go To Multimedia”
into the microphone. The Multimedia menu appears in the display. Press for Camera.
2. Point the camera lens at your subject.
3. Using the display as a viewfinder, press the key when the image that
you wish to capture appears in the display.
4. Press the Save (left) soft key ( ) to save the picture to the Image
gallery in your phone, a part of the phone’s memory devoted to storing,
browsing, and viewing saved pictures.
Press the SEND key ( ) to save the picture and include it in a Picture
message. (See “Send Picture Messages in Camera Mode” on page 73 for
more information.)
Press the Erase (right) soft key ( ) to erase the photo.
Tip: You can change a number of the camera’s settings to suit particular uses for your pictures. See
“Camera Shortcuts” on page 102 for more information.
OK
@
@
OK
OK