Filter
Top Products
90
ⅷ User ID: enter the User ID required to connect to the network.
ⅷ Password: enter the user password required to connect to the network.
ⅷ Protocol: set the connection protocol used by the WAP browser: WAP, HTTP, or
Other.
ⅷ Home URL: enter the URL address of the page to be used as your homepage.
ⅷ Gateway address: (wap1.x only) enter the gateway address of the proxy server.
ⅷ Proxy address: (wap2.x and Cingualr MMS) set the proxy server address and
port.
ⅷ Port: enter the connection port.
ⅷ Linger Time (Sec.): set a time period (in seconds) after which the network is
disconnected if there has been no new data traffic in that time.
ⅷ Advanced Settings: allows you to configure some of the IP-specific
information: Static IP, Static DNS, Server information, and Traffic Class.
ⅷ Static IP: specify if you want to manually enter an IP address. If you want the
IP address to be automatically assigned by the server, remove the check mark.
ⅷ Local phone IP: enter the IP address obtained from the network operator, if
you checked the Static IP option.
ⅷ Static DNS: specify if you want to manually enter the Domain Name Server
(DNS) address. If you want the address to be automatically assigned by the
server, remove the check mark.
ⅷ Server 1/Server 2: enter the Domain Name Server (DNS) addresses.
ⅷ Traffic class: select the traffic class.
Note: The WAP settings may vary depending on the service provider.
Configuring your Phone’s USB Connection
Your phone can connect to a PC via the included USB cable.The phone can be
configured to open launch a default application when an active USB connection is
detected.
1. Use the USB adapter cable to connect the handset to the target PC. When
an active connection has been established, a USB icon ( ) appears on
the phone.
2. When the Idle screen displays, press the Menu soft key.
3. Select Settings and press the Select soft key or the key.