Phone Basics
Phone Basics
Turning Your Phone On and Off
Turning Your Phone On
ᮣ
Press and hold .
Once your phone is on and finds a signal, it automatically
enters standby mode – the phone’s idle state. At this point, you
are ready to begin making and receiving calls.
If your phone is unable to find a signal after 15 minutes of
searching, a Power Save feature is automatically activated.
When a signal is found, your phone automatically returns to
standby mode.
In Power Save mode, your phone searches for a signal
periodically without your intervention. You can also initiate a
search for service by pressing any key except numbered keys.
Turning Your Phone Off
ᮣ
Press and hold for two seconds until you see the
powering-down animation on the display screen.
Your screen remains blank while your phone is off unless the
battery is charging.
Battery and Charger
Battery Capacity
Your phone is equipped with a Lithium Ion (Li-Ion) battery. It
allows you to recharge your battery before it is fully drained.
The battery provides up to 4.8 hours of continuous digital talk
time.
For a quick check of your battery level, glance at the battery
charge indicator located in the upper-right corner of your
phone’s display screen. When there are approximately five
minutes of talk time left, the battery icon ( ) turns red and
the phone sounds a warning tone.
WARNING
Use only Kyocera-approved batteries and
chargers with your phone. The failure to use a
Kyocera-approved battery and charger may
increase the risk that your phone will overheat,
catch fire, or explode, resulting in serious bodily
injury, death, or property damage.
Tip
The Power Save feature conserves your battery power
when you are in an area where there is no signal.
2A. Phone Basics 11
PLS_Sanyo 2700_UG (080509)_PLS_UG 2009/08/05 19:37 ページ 11