Filter
Top Products
After an additional five minutes or so, the phone sounds a
warning tone three times and then turns off.
Installingthe Battery
1. Insert the battery into the opening on the back of the
phone, making sure the connectors align( ), and gently
press it down ( ).
2. Replace the battery cover and press it down until the latch
snaps into place ( and ).
Removing the Battery
1. Make sure the power is off so that you don’t lose any
stored numbers or messages.
2. Slide the battery release latch in the direction of the arrow
( ), pull the battery cover up, and remove it ( ).
3. Lift the battery up and remove it from the phone ( ).
WARNING
Do not handle a damaged or leaking
Li-Ion battery as you can be burned.
Tip
Watch your phone’s battery level indicatorand charge
the battery before it runs out of power.
Note
Long backlight settings, searching for service, vibrate
mode, browser use, and other variables may reduce the
battery’s talk and standby times.
12 2A. Phone Basics
PLS_Sanyo 2700_UG (080509)_PLS_UG 2009/08/05 19:37 ページ 12