Support User Manuals

Sierra Wireless 20070914 Cell Phone User Manual

Open as PDF

of 171

Configuration Commands

Rev 3.0B Feb.08 93

Status

Mostofthecommandsinthe“Status”grouphaveread‐only

parametersandprovideinformationaboutthemodem.The

StatusGrouphasmorefieldsthatcanbedisplayedonmost

screens.Youcaneitherresizeyourwindoworusethescroll

baronthesidetodisplaytheremainder.

Figure 1-2: AceManager : Status

*HOSTMODE?

Thecurrenthostmode(AT,PPP,UDP,etc.).IftheRavenisnot

inATmode,telnetintothemodemtoexecutethiscommand.

*NETCHAN?

Thecurrentactive1x/CDMAchannelnumber.

*NETERR?

TheEVDOorCDMAnetworkframeerrorrate.

*NETIP?

Note: If there is no current

network IP address, 0.0.0.0 may

be displayed.

ThecurrentIPaddressofthemodemreportedbytheinternal

module,generallyobtainedfromTELUS.Thisistheaddress

cancontacttheRavenfromtheInternet.

Tip: Use *NETALLOWZEROIP if you need to allow the display of an

IP ending in a zero.

previous next