Vidikron 80 Cell Phone User Manual


 
13
Indicator Display on the Control Panel
 


 

 

 

 

 

 

 

 

 

 

 












 











































In addition to the standby mode, operate mode and cool down mode*, this unit also displays other operational states using diff erent
combination of indicators.
• Please refer to Page 29 for explanations on warning indication for *1 and Page 32 for *2.
*About Cool Down Mode
After projection, the heated lamp will go through a 90-second
cool-down process known as the cool down mode. This function
is to prevent damage and deformation that heat from the heated
lamp may cause to the internal components of this unit. It also pre-
vents lamp breakage and shortened lamp life.
The cool down mode is indicated by the blinking [STAND BY] in-
dicator. When in the cool down mode, the [OPERATE] button will
be disabled.
After the cool down process is completed, the unit will automati-
cally switch to the standby mode.
Note
When in the cool down mode, do not pull out the plug from the
power outlet. Also, do not block the air inlets/exhaust vents.