Filter
Top Products
26
1 “Picture adjust” Menu
To adjust images.
On the “Picture Adj.” menu, you can adjust the following items.
“Gamma”
Switches the gradation characteristics of the image. Select your
preference setting values according to the image to be viewed.
Setting Values : “NORMAL”, “A”, “B”, “CUSTOM”
“CUSTOM” : Use when setting Gamma with optional software.
The picture quality is same as “NORMAL” for factory
setting.
“White Bal.”
Adjusts the color temperature of the projected image.
Setting Values : “6500”, “CUST1”, “CUST2”
“RED” : -255 to 0
“GREEN” : -255 to 0
“BLUE” : -255 to 0
“Test pattern”
Use this to adjust focus, screen size or picture quality. There are 10
types of test patterns. Press the [ENTER] or [TEST] button to alter the
test pattern to be projected.
2 “Projector Opt” Menu
The following items can be set at the “Set up” menu.
“OSD position”
Adjusts the display position of the menu screen.
Setting Values (menu display position):
“Blanking”
Masks (hides) the outer area of the projected image.
Setting Values : “2.5%”, “5%”, “Off ”
“Source”
Sets the image format for video image signals that are input to
this unit.
Ensure to align settings between this unit and the digital video
processor that is connected.
Setting Values : “60P”, “50P”
3 “Options” Menu
The following items can be set at the “Options” menu.
“OSD Timer”
Adjusts the display duration of the menu screen.
Setting Values : “15 sec”, “On”
“H Orientation”
Reverses image to the left or right.
Setting Values : “FRNT”, “REAR”
“V Orientation”
Inverses image upside down.
Setting Values : “FLR”, “CEIL”
“V shift”
When projecting images with black bands at the top and bottom
(cinema image), use this to move the image up or down while re-
taining one of the black bands at the upper or lower end.
Setting Values : -30 to 30
“Sleep time”
Sets the lapse time before automatically switching the unit to the
standby mode when there is no signal input.
Setting Values : “15”, “30”, “60”, “Off ”
“RS232C (baud)”
Sets the communication speed (signal transmission speed) when
communicating with automation equipment using the RS-232C
terminal. Ensure that this is same as the rate set at the automation
unit.
Setting Values : “9600”, “19200”
4 “Information” Menu
“Lamp Hour”
Displays the accumulated hours of usage of the light-source
Adjustments and Settings Using Menus (continued)