Filter
Top Products
22
5
Turning on the power
1
Press the [POWER] button on this unit (or the [OFF] button
Press the [POWER] button on this unit (or the [OFF] button
on the remote control) for 1 or more seconds.
• The [POWER] indicator turns off , the [STAND BY] indicator
starts blinking and this unit switches to the cool down mode.
The cool down mode is to allow the temperature of the light
source lamp to cool off .
LAMP TEMP
STAND BY
POWER
Light onLight off
Projecto
r: Indicator
1
Note
• The [POWER] button will not work within approximately 1 min-
ute after the light source has been turned on. Start operation
only after 1 minute’s time.
4
Hiding the image temporarily
Press [MUTE]
• The displayed image will disappear.
• Press [MUTE] again to restore the image.
2
Pull out the power plug from the power outlet.
Pull out the power plug from the power outlet.
Note
• Do not pull out the plug when the [STAND BY] indicator is blink-
ing. This may shorten the lamp life
Basic Operation (continued)