Filter
Top Products
33
Troubleshooting
Before sending the unit to your Vidikron dealer for repair, check the following points.
Symptom Probable Cause Corrective Action Reference Page
Power is not supplied.
• Is the power cord disconnected?
• Insert the power cord (plug) fi rmly.
4 – 6, 20
• Is the lamp cover properly shut?
• Contact your Vidikron dealer for
service.
29
• Is the fi lter cover properly shut?
• Contact your Vidikron dealer for
service.
30
• Has the lamp life expired? (Has the
lamp usage time reached 2000
hours?)
• Contact your Vidikron dealer for
installation of a new lamp.
29
Light is not emitted or light is dim.
• Is the lamp near exhaustion?
• Check the lamp time on the menu.
Contact your Vidikron dealer to
replace as soon as possible when the
lamp is near exhaustion.
23
Unit works when power is turned
on but stops abruptly after a few
minutes.
• Are the air suction openings (air
inlets) and exhaust vents blocked?
• Remove the plug when the [STAND
BY] indicator is on. Remove any
blocking object and insert the plug
again.
30
• Are the fi lters dirty?
• Have your Vidikron dealer clean the
fi lters.
30
Video image does not appear.
• Are devices properly connected?
• Connect devices correctly.
19
• Are signals being output from the
connected devices?
• Set connected devices correctly.
• Is the video image temporarily
turned off when the [MUTE] button
is being pressed?
• Press the [MUTE] button to display
the video image again.
14
Video image is fuzzy.
• Is the focus correctly adjusted?
• Adjust accordingly using the focus
ring.
21
• Is the unit placed too near or too far
away from the screen?
• Set the unit at a correct distance
from the screen.
16
Video images are missing.
• Has setting been performed for
screen blanking?
• Set the “Blanking” value in the “Set
up” menu to “OFF”.
27
• Has setting been performed for V
shift?
• Alter the “V Shift” value in the “Op-
tions” menu to ensure that images
are not missing.
28
Remote control unit does not work.
• Are batteries installed correctly?
• Match the polarities (+ or -) correctly
when inserting the batteries.
• Are batteries exhausted?
• Replace with new batteries.
• Is there an obstructive object be-
tween the remote control unit and
remote sensor?
• Remove any obstructive objects.
18
• Is the remote control held too far
away from the screen?
• Hold the remote control closer to
the sensor when using.
18
• This unit uses a microcomputer. External noise may cause it to malfunction. If this happens, turn off the power and remove the plug from
the power outlet. Insert plug again into the outlet and check operation of the unit. (See Pages 4–6, 20 on how to turn on/off the power
of the unit.)