Filter
Top Products
5
– Slots and openings in the cabinet are provided for ventilation.
These ensure reliable operation of the product and protect it
from overheating. These openings must not be blocked or cov-
ered. (The openings should never be blocked by placing the prod-
uct on bed, sofa, rug, or similar surface. It should not be placed
in a built-in installation such as a bookcase or rack unless proper
ventilation is provided and the manufacturer’s instructions have
been adhered to.) For proper ventilation, separate the product
from other equipment, which may prevent ventilation and keep a
distance of more than 11-7/8” (30 cm).
– This product should be operated only with the type of power
source indicated on the label. If you are not sure of the type of
power supply to your home, consult your product dealer or local
power company.
– This product is equipped with a three-wire plug. This plug will fi t
only into a grounded power outlet. If you are unable to insert the
plug into the outlet, contact your electrician to install the proper
outlet. Do not defeat the safety purpose of the grounded plug.
– Power-supply cords should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them.
Pay particular attention to cords at doors, plugs, receptacles, and
the point where they exit from the product.
– For added protection of this product during a lightning storm, or
when it is left unattended and unused for long periods of time,
unplug it from the wall outlet and disconnect the cable system.
This will prevent damage to the product due to lightning and
power line surges.
– Do not overload wall outlets, extension cords, or convenience re-
ceptacles on other equipment as this can result in a risk of fi re or
electric shock.
– Never push objects of any kind into this product through open-
ings as they may touch dangerous voltage points or short out
parts that could result in a fi re or electric shock. Never spill liquid
of any kind on the product.
– Do not attempt to service this product yourself as opening or re-
moving covers may expose you to dangerous voltages and other
hazards. Refer all service to qualifi ed service personnel.
– Unplug this product from the wall outlet and refer service to qual-
ifi ed service personnel under the following conditions:
a) When the power supply cord or plug is damaged.
b) If liquid has been spilled, or objects have fallen on the prod-
uct.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the op-
erating instructions. Adjust only those controls that are cov-
ered by the Operation Manual, as an improper adjustment of
controls may result in damage and will often require extensive
work by a qualifi ed technician to restore the product to normal
operation.
e) If the product has been dropped or damaged in any way.
f) When the product exhibits a distinct change in performance
- this indicates a need for service.
– When replacement parts are required, be sure the service techni-
cian has used replacement parts specifi ed by the manufacturer or
with same characteristics as the original part. Unauthorized sub-
stitutions may result in fi re, electric shock, or other hazards.
– Upon completion of any service or repairs to this product, ask the
service technician to perform safety checks to determine that the
product is in proper operating condition.
– The product should be placed more than one foot away from
heat sources such as radiators, heat registers, stoves, and other
products (including amplifi ers) that produce heat.
– When connecting other products such as VCR’s, and personal
computers, you should turn off the power of this product for pro-
tection against electric shock.
– Do not place combustibles behind the cooling fan. For example,
cloth, paper, matches, aerosol cans or gas lighters that present
special hazards when over heated.
– Do not look into the projection lens while the illumination lamp
is turned on. Exposure of your eyes to the strong light can result
in impaired eyesight.
– Do not look into the inside of this unit through vents (ventilation
holes), etc. Do not look at the illumination lamp directly by open-
ing the cabinet while the illumination lamp is turned on. The il-
lumination lamp also contains ultraviolet rays and the light is so
powerful that your eyesight can be impaired.
– Do not drop, hit, or damage the lamp in any way. It may cause
the light-source lamp to break and lead to injuries. Do not use
a damaged light source lamp. If the light-source lamp is broken,
ask your dealer to repair it. Fragments from a broken light-source
lamp may cause injuries.
– The lamp used in this projector is a high pressure mercury lamp.
Be careful when disposing of the light-source lamp. If anything is
unclear, please consult your dealer.
– Do not ceiling-mount the projector to a place which tends to vi-
brate; otherwise, the attaching fi xture of the projector could be
broken by the vibration, possibly causing it to fall or overturn,
which could lead to personal injury.
– Use only the accessory cord designed for this product to prevent
shock. The power supply voltage rating of this product is AC 120
V, AC 100 V – AC 240 V, the power cord attached conforms to the
following power supply voltage. Use only the power cord desig-
nated by our dealer to ensure Safety and EMC. When it is used
by other power supply voltage, power cable must be changed.
Ensure that the power cable used for the projector is the cor-
rect type for the AC outlet in your country. Consult your product
dealer.
*DO NOT allow any unqualifi ed person to install the unit.
Be sure to ask your Vidikron dealer to install the unit (e.g. attach-
ing it to the ceiling) since special technical knowledge and skills
are required for installation.
If installation is performed by an unqualifi ed person, it may
cause personal injury or electrical shock.
Power supply voltage: AC 120 V
Power cord