4 – OPERATOR SERVICE
33
Error Message
Displayed
Error Explanation &
Possible Causes
What To Check &
Corrective Action To Clear Error
010 LEVEL SENSOR HAS
ERRATIC OUTPUT
The Lower Control has detected a rapidly changing
output from the level sensor.
This is a self clearing error. When error condition is
removed, error is cleared.
Possible causes include:
1. Faulty Level Sensor
2. Faulty Level Sensor wiring
3. Faulty Lower Control
1. Check Level Sensor
2. Repair or replace Level Sensor wiring
3. Replace Lower Control
NOTE: With machine powered and level, Level
Sensor should have a steady approximately 24 volt
supply voltage and a steady approximately 2.50 volt
output on both X and Y outputs with respect to the
Level Sensor ground connection.
011 TRYING TO DRIVE
W/ TRAILER BRAKE OFF
An attempt was made to drive machine without
engaging the trailer brake.
This is a self clearing error. When error condition is
removed, error is cleared.
NOTE: This error only occurs on machines equipped
with the Drive & Set option.
Possible causes include:
1. Trailer brake not engaged
2. Faulty trailer brake switch
3. Faulty trailer brake switch wiring
4. Faulty Lower Control
1. Engage trailer brake
2. Check and repair trailer brake switch
3. Repair or replace trailer brake switch wiring
4. Replace Lower Control
012 ANGLE SENSOR IS
DISCONNECTED OR BAD
The Lower Control has detected the angle sensor
output is out of range.
This is a self clearing error. When error condition is
removed, error is cleared.
NOTE: This error only occurs on machines equipped
with the Moment Sense option.
Possible causes include:
1. Faulty angle sensor
2. Faulty angle sensor wiring
3. Lower Control incorrectly configured
4. Faulty Lower Control
1. Check angle sensor
2. Repair or replace angle sensor wiring
3. Correctly configure Lower Control
4. Replace Lower Control
013 PRESSURE SENSOR IS
DISCONNECTED OR BAD
The Lower Control has detected the pressure sensor
output is out of range.
This is a self clearing error. When error condition is
removed, error is cleared.
NOTE: This error only occurs on machines equipped
with the Moment Sense option.
Possible causes include:
1. Faulty pressure sensor
2. Faulty pressure sensor wiring
3. Lower Control incorrectly configured
4. Faulty Lower Control
1. Check pressure sensor
2. Repair or replace pressure sensor wiring
3. Correctly configure Lower Control
4. Replace Lower Control
014 CHECK ENGINE
LOW OIL PRESSURE
The Lower Control has detected the engine had low
oil pressure while running.
This is a latched error. To clear this error, first the
error condition must be removed and second the
power must be cycled off then back on.
NOTE: This error only occurs on machines equipped
with the X-Boom option.
Possible causes include:
1. Engine oil low
2. Faulty oil pressure sensor
3. Faulty oil pressure sensor wiring
4. Lower Control incorrectly configured
5. Faulty Lower Control
1. Check engine oil level
2. Check oil pressure sensor
3. Repair or replace oil pressure sensor wiring
4. Correctly configure Lower Control
5. Replace Lower Control
