ENGLISH
Simple
Version
Remote
Control
Playback
(Advanced)
Connections
Playback
(Basic)
Multi-
zone
GUISettings
Getting
Started
Troubleshooting
Other
Information
Spec. Index
Part
Names
Error Messages
An error message is displayed if Audyssey™ Auto Setup could not be completed due to speaker placement, the measurement environment, etc. If this happens,
check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.
NOTE
Be sure to turn off the power before checking speaker connections.
Examples Error details Measures
Caution!
No microphone or speaker
The connected setup microphone is broken, or a
device other than the supplied setup microphone
is connected.
Not all speakers could be detected.
The front L speaker was not properly detected.
•
•
•
Connect the included setup microphone to the
SETUP MIC jack of this unit.
Check the speaker connections.
•
•
Caution!
Ambinet noise is too high
or Level is too low
There is too much noise in the room for accurate
measurements to be made.
Speaker or subwoofer sound is too low for accurate
measurements to be made.
•
•
Either turn off any device generating noise or move
it away.
Perform again when the surroundings are quieter.
Check the speaker installation and the direction in
which the speakers are facing.
Adjust the subwoofer’s volume.
•
•
•
•
Caution!
Front R None
The displayed speaker could not be detected.• Check the connections of the displayed speaker.•
Caution!
Front L Phase
The displayed is connected with the polarities
reversed.
• Check the polarities of the displayed speaker.
For some speakers, this error message may be
displayed even if the speaker is properly connected.
If you are sure the connection is correct, press ui
to select “Skip”, then press ENTER.
•
•
