ENGLISH
Remote
Control
Playback
(Advanced)
Connections
Simple
Version
Playback
(Basic)
Multi-
zone
GUISettings
Getting
Started
Troubleshooting
Other
Information
Spec. Index
Part
Names
W4 AUDYSSEY MULTEQ
®
indicators
Lighting is as follows, depending on the setting
of “Dynamic EQ” (vpage 51) and “Dynamic
Volume” (vpage 52).
When “Dynamic EQ” and “Dynamic
Volume” are “ON”.
When “Dynamic EQ” is “ON” and
“Dynamic Volume” is “OFF”.
When “Dynamic EQ” and “Dynamic
Volume” are “OFF”.
W5 SLEEP indicator
This lights when the sleep mode is selected.
W6 RESTORER indicator
This lights when the RESTORER mode is
selected (vpage 26).
W7 ZONE2 indicators
This lights up when ZONE2 (separate room)
power is turned on.
W8 AL24 indicator
This lights when AL24 Processing (vpage 67) is
activated.
W9 Input mode indicators
Set the audio input modes for the different input
sources (vpage 47).
E0 HDMI indicator
This lights when playing using HDMI connections.
E1 Tuner reception mode indicators
These light according to the reception conditions
when the input source is set to “TUNER”.
STEREO: In the FM mode, these light when
receiving analog stereo broadcasts.
TUNED: Lights when the broadcast is properly
tuned in.
AUTO: These light when in the auto tuning
mode.
E2 Decoder indicators
These light when the respective decoders are
operating.
Rear Panel
See the page indicated in parentheses ( ).
q w e rt u i o Q0y r
Q1Q4 Q2Q3Q3Q5
q ETHERNET connector ································(16)
w TRIGGER OUT jack ·····································(17)
e S-VIDEO connector ····································(14)
r OPTICAL connector ······························(13, 15)
t DOCK CONTROL jack ·································(14)
y REMOTE CONTROL jacks ··························(17)
u RS-232C connector ·····································(17)
i FM/AM antenna terminals ························(15)
o Speaker terminals ··································(4, 35)
Q0 AC inlet (AC IN) ·············································(5)
Q1 ZONE2 OUT connectors ·····························(41)
Q2 PREOUT connectors ···································(35)
Q3 Analog audio connectors ··················· (13 – 15)
Q4 HDMI connectors ········································(12)
Q5 COAXIAL connector ···························(13 – 15)
When using the COAXIAL connector, set “Manual
Setup” – “Audio Setup” – “COAX Input Assign”
(vpage 56) on the GUI menu to “AUX1” or
“AUX2”.
NOTE
Do not touch the inner pins of the connectors on
the rear panel. Electrostatic discharge may cause
permanent damage to the unit.
Do not put your finger or foreign object in the
fan opening. Doing so could cause injury or unit
failure.
•
•
Front Panel / Top Panel / Display
