ENGLISH
Remote
Control
Playback
(Advanced)
Connections
Simple
Version
Playback
(Basic)
Multi-
zone
GUISettings
Getting
Started
Troubleshooting
Other
Information
Spec. Index
Part
Names
Source Select
Perform settings related to input source playback.
You do not have to change the settings to use the unit. Make settings when needed.
Items that can be Set with the Source Select Procedure
Input Mode vpage 47
Decode Mode vpage 47
Rename vpage 47
Auto Preset vpage 48
Preset Name vpage 48
n
Important Information
About the Display of Input Sources
In this section, the configurable input sources for each item are shown as follows.
BD/SD
HDMI1
HDMI2
HDMI3
FM
AM
USB
AUX1
AUX2
To perform the following settings, select the input source and then select the items you want to set.
GTo select the input sourceH Use ui to select the input source and press p.
Input Mode
Default settings are underlined.
The input modes available for selection may vary depending on the input source.
Setting items Setting details
Input Mode
Set the audio input modes
for the AUX1/2.
AUX1
AUX2
Auto : Automatically detect input signal and perform playback.
Digital : Play only signals from digital input.
Analog : Play only signals from analog input.
When digital signals are properly input, the indicator lights on
the display. If the indicator does not light, check the digital input
connector assignment and the connections.
•
Decode Mode
Default settings are underlined.
Set the decode mode for input source.
Setting items Setting details
Decode Mode
Set the decode mode for
input source.
BD/SD
HDMI1
HDMI2
HDMI3
AUX1
AUX2
Auto : Detect type of digital input signal and decode and play
automatically.
PCM : Decode and play only PCM input signals.
DTS : Decode and play only DTS input signals.
Normally set this mode to “Auto”. Set “PCM” and “DTS” when
inputting the corresponding input signal.
Rename
Change the display name of the selected input source.
Setting items Setting details
Rename
Change the display name of
the selected input source.
BD/SD
HDMI1
HDMI2
HDMI3
FM
AM
USB
AUX1
AUX2
When the input source is
HDMI1
,
HDMI2
,
HDMI3
,
AUX1
, or
AUX2
, you
can change the displayed
icon.
•
•
1. Press p or ENTER.
2. Press o p, align the cursor to the icon to be changed, and press
ENTER.
At this time, the input source name is also automatically changed.•
3. To change the input source name, press ui to
change the characters, and press ENTER.
Up to eight characters can be input.
The input character type can be switched by
pressing SEARCH while the display name is
being changed.
The types of characters that can be input are as
shown below.
•
•
•
Rear
GUpper case charactersH
ABCDEFGHIJKLMNOPQRSTUVWXYZ
GLower case charactersH
abcdefghijklmnopqrstuvwxyz
GSymbolsH
! # % & ‘ ( ) * + , - . / : ; < = “ > ? @ [ \ ]
GNumbersH
0123456789 (Space)
4. Repeat steps 2 and 3 to change the display name.
Default
Reset all settings to factory
default.
No
Yes
Remote control operation
buttons
Display the menu
Cancel the menu
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu
