ENGLISH
Remote
Control
Playback
(Advanced)
Connections
Simple
Version
Playback
(Basic)
Multi-
zone
GUISettings
Getting
Started
Troubleshooting
Other
Information
Spec. Index
Part
Names
Playback (Multi-zone Function) in ZONE2 (Separate Room)
You can operate this unit so as to enjoy audio and video in a room (ZONE2) other than the MAIN ZONE
(room where the unit is located).
You can simultaneously play back the same source in both the MAIN ZONE and ZONE2. You can also
play back separate sources in the MAIN ZONE and ZONE2.
Multi-zone Connections
This unit
MAIN ZONE ZONE2
Pre main
amplifier
See “REMOTE CONTROL Jacks” (vpage 17) for connection information concerning remote
control operation in ZONE2.
Audio and video Signals which can be Output in ZONE2
Audio
Audio from a disc or SD memory card played back on this unit
A multichannel source is converted to a 2-channel downmix signal and output.
Analog audio input to this unit
Audio of a device connected to the USB port
Control dock for iPod (analog audio)
Video
Video from a disc or SD memory card played back on this unit
Video input to this unit from a Control dock for iPod
We recommend using high quality pin-plug cables for audio and video connections in order to prevent
noise.
NOTE
Audio and video input to this unit via HDMI is not output.
The GUI menu screen is not output.
DENON control dock for iPod ASD-11R switches to Browse Mode and cannot be operated.
The following media and sources cannot be played back simultaneously in the MAIN ZONE and ZONE2.
Disc (BD/DVD/CD) and SD memory card
FM and AM
•
•
•
n
•
•
•
•
n
•
•
•
•
•
•
•
•
Playback
1
Turn on the pre main amplier for
ZONE2.
Front
Input source
select buttons
2
Switch DEVICE SELECT to
“ZONE2”.
The remote control unit switches to the
operating mode for ZONE2.
3
Press ON to turn on the ZONE2
power.
The indicator on the display lights.
Also press input source select button when in
standby mode, the power turns on.
When OFF is pressed, ZONE2 turns off.
NOTE
When ZONE2 is powered on, the HDMI
video resolution in the MAIN ZONE switches
automatically according to the input signal.
When this happens, it is not possible to switch
to a different video resolution, even by pressing
RESOLUTION.
•
•
4
Press input source select button.
The audio/video signal of the selected
source is output to ZONE2.
To switch the source output to ZONE2 to the
source playing back at the MAIN ZONE, press
SOURCE SELECT.
•
5
Adjust the volume of the pre main amplier for
ZONE2.
