VISORNET - Installation
I-29
Doc. DM245-I
Rev. 7.0
To ignore the configuration
Switch off the device.
Using a screwdriver, put microswitch number five in
the ON position.
Switch on the device. The device will then discard
the existing configuration and stores the
manufacturer’s configuration.
Switch off the device again.
Using a screwdriver, return microswitch number 5 to
the OFF position.
Switch on the device and proceed to reconfigure the
device again following the steps given in the User
manual Dm246-I.
I - 5.2. Device stacking
The SW3 rotary switch is used to configure the device in installations where one
VisorNet 4c takes over the role of master with a group of up to 3 VisorNet 4c act as
slaves (Slaves 1, 2 or 3). In the User manual (Dm246-I) you will find detailed
explanations on the implications that this configuration has over the operation of the
devices.
4
1
3
ON
5
6
7
8
SW1
SW3
Figure 1.20. Master/slaves configuration rotary switch located on the underside
of the device
The device leaves the factory configured as master with the rotary switch set on “0”.
In order to configure a device as slave, carry out the following steps:
