A SERVICE OF

logo

VISORNET - Installation
I-30
Doc. DM245-I
Rev. 7.0
To configure the device as slave
Switch off the device.
Using a screwdriver set microswitch number 5 in the
ON position and select the slave number you wish in
the rotary switch. The permitted values are 1, 2 and
3.
Switch on the device. Your device will then discard
the existing configuration and stores the
manufacturer’s configuration for a slave device.
Switch off the device once more.
Using a screwdriver, set microswitch number five in
the OFF position again.
Switch on the device. Proceed to configure the
device again following the steps given in the next
chapter for slave devices.