Filter
Top Products
Your phone
Copyright © 2004 Nokia. All rights reserved. 9
• Unlocking the keypad
Press Unlock and then
within 1.5 seconds, or if the
Security keyguard is set On, press
Unlock and key in the security
code.
To answer a call when the keyguard
is on, press . During a call, the
phone can be operated normally.
When you end or reject the call, the
keypad will automatically be locked.
For automatic keypad locking, see
”Phone settings” on page 60.
For locking the keypad during a call,
see ”Options during a call” on page
11.
Note: When Keyguard is on,
calls may be possible to the
emergency number
programmed into your
phone (e.g. 112, 911 or other
official emergency number).
Key in the emergency
number and press .
The number is displayed only
after you have keyed in its
last digit.
■ Over the air settings
service
In order to use MMS, (E)GPRS and
other wireless services, you need to
have proper connection settings on
your phone. You may receive the
settings directly as an over the air
message and you need to save the
settings on your phone. For more
information on the availability of the
settings, contact your network
operator, service provider or nearest
authorised Nokia dealer.
You may be able to receive the
connection settings for (E)GPRS,
multimedia messages,
synchronisation, chat and presence
and for multi-mode browser.
When you have received the
connection settings as an over the
air message, and the settings are not
automatically saved and activated,
Connection settings received is
displayed.
• To save the received settings,
press Options and select Save. If
the phone asks Enter settings'
PIN:, key in the PIN code for the
settings and press OK. For
availability of the PIN code,
contact the service provider that
supplies the settings.
If no settings are saved yet, these
settings are saved under the first
free connection set.
• To view the received settings
first, press Options and select
View. To save the settings, press
Save.
• To discard the received settings,
press Options and select Discard.
To activate the settings, see, for
example ”Making a connection to a
service” on page 86.