Filter
Top Products
18
©2000 Nokia Mobile Phones. All rights reserved.
To charge a battery
1 Make sure that the battery is properly installed in the battery
compartment.
2 Connect the charger lead to the connector at the bottom of the
communicator, as shown in figure 11.
3 Connect the charger to an AC wall outlet. If the phone is switched on, the
CHARGING message appears on the display and the segments of the battery
indicator bar on the right side of the phone display will start scrolling.
4 When the battery is fully charged, the bars stop scrolling and four bars are
displayed. You may now remove the charger plug from the communicator.
When the charge in the battery is low and only a few minutes of operation
time remain, a warning tone will sound, and the message BATTERY IS LOW will
be repeated at regular intervals on the phone display. When the charge level
becomes too low for operation, the RECHARGE BATTERY message will be
displayed, accompanied by a warning tone. If you do not connect the
communicator to a charger, the communicator switches itself off.
Figure 11
Note: If the battery is fully discharged, it will
take 30 - 60 seconds before the CHARGING
message appears on the display and the battery
indicator bar starts scrolling. After that, it may
take 10-30 seconds before you can switch the
phone on.
Um_spock3.bk Page 18 Thursday, June 1, 2000 10:11 AM