Filter
Top Products
7
Attaching the battery when using optional
analog module
1)
Place the analog
module on the back of
the phone
2)
Slide the module
toward the top of the
phone until it clicks into
place
3)
Place the battery
on top of the analog
module
4)
Slide the battery toward the top of the phone until
it clicks into place
Charging your new battery
Your phone is powered by a rechargeable Li-Ion or
NiMH battery, which should be charged for 24 hours
without interruption. Note that a new NiMH batterys
full performance is achieved only after two or three
complete charge and discharge cycles.
Note: Use only batteries approved by the phone manufacturer
and recharge your battery only with the chargers approved by
the manufacturer.
Also, see Important Battery Information on page 98 for
important battery usage information and Talk and Standby
Times on page 90 for approximate battery operation times.
With your phone on or off, simply connect the lead
from the charger to the bottom of your phone or place
it on a charging stand. Then connect the charger to a
standard 120V AC outlet.
Note: If you have purchased an optional analog module, be
sure to remove it and replace the battery before placing the
phone in a charging stand. Although the phone will fit in the
stand with the analog module attached, charging will not take
place.
When the battery begins charging, the battery
strength indicator on the right side of the display will
scroll and your phone will beep once. When you