Filter
Top Products
E-28
5. Handling After Shooting
Wipe off any waterdrop.
After underwater shooting,
remove any drops of water from
the case. Use pressurized air or
a soft, lint-free cloth to carefully
wipe away any moisture from the
hinge between the front and rear
lids, the shutter release lever, the
handgrip and the buckles.
: • Water left between the front and rear lids or between
the case and port can get inside the case once it is
opened or the port is detached. Please dry these
areas carefully.
• When opening the case or removing the port, make
sure no water from outside (e.g. drops from your hair
or the diving suit) gets inside of the case and/or on
the camera!
• Before opening the case or removing the port, ensure
that your hands or gloves are completely clean (free
of sand, loose fibers, etc.).
• Never open the case or remove the port in areas
where water could splash or spray or where sand or
dust could be blown in the air. When this cannot be
avoided, for example if the battery or memory card
needs to be changed, the case and camera should be
protected from the wind or spray with a plastic sheet
or similar object.)
• Never touch the digital camera and/or battery you're
your hands are wet with sea water.
Note
: • Moisten a cloth or towel with tap water and keep it in
a plastic bag. Use this to wipe the salt water or
crystals from your hands before you touch the
camera.
CAUTION