Filter
Top Products
E-33
: • Always perform maintenance of the waterproof
function even when the Case has been opened to
exchange the battery or the image storage during
shooting. Neglecting this maintenance may become
the cause of water leakage.
• When the Case is not to be used for a long time,
remove the O-ring from the groove to prevent
deformation of the O-ring, apply a thin coat of silicone
grease, and store it in a clean plastic bag or the like.
• When drying is done with salt attached, it is likely that
a function impairment will be caused. After use,
always wash off any salt.
CAUTION
Clean and apply O-ring
silicon grease to these
sections.
Maintenance of the threaded sections on the
TTL cable and TTL cable connector
If the threaded sections used to connect the TTL cable to the TTL cable
connector are not maintained properly, salt and other seawater residue
may adhere the TTL cable and prevent it from being disconnected.
After use in seawater, clean off any salt, sand, or other residue as soon
as possible, then dry the equipment thoroughly. Clean the threaded
sections with a cotton swab and apply a thin, uniform layer of O-ring
silicon grease (provided with this case).
Maintenance of the TTL Connector Cap
After removing the TTL connector cap from the waterproof cap, be sure
to clean and grease the O-ring.
Use the waterproof cap maintenance adapter to remove the O-ring unit
from the waterproof cap.
Waterproof cap Waterproof cap
maintenance adapter