Filter
Top Products
Using Speed Dialing
With this feature, you can dial Speed Dial entries using one key
press for locations 2-9. (See page 66 for storing a Speed Dial
number.)
To use speed dial for voice calls:
ᮣ
From standby mode, press and hold the appropriate key for
approximately two seconds.
– or –
From standby mode, press the appropriate key and
press or .
The display confirms that the number has been dialed when it
shows “Connecting...”.
To use speed dial for 10-4 calls:
ᮣ
From standby mode, press the appropriate key then press .
(See “Setting Speed Dialing for 10-4 Entries” on page 102.)
The display confirms that the number has been dialed when it
shows “10-4 calling...”.
Using Abbreviated Dialing
Abbreviated Dialing allows you to dial a number by entering 3-6
digits of any number in your Contacts Directory. (See “Setting
Abbreviated Dialing” on page 48.)
1. Dial the last 3-6 digits of a contact’s phone number.
2. Press or . If there is more than one matched number
in your Contacts list, Abbrev. Dial list appears.
3. Select the name you want to call, and then press or
to place a call.
Tip: You can also place a call by pressing (right softkey) and
select Abbrev. Dial after step 1 above.
Note: When Ph. Book Match is set to Enable and your desired number
is saved in
Contacts (regardless of whether Prepend is enabled or
disabled), you can display the number by entering its last three to six
digits. (See page 48 for Ph. Book Match and Prepend.)
Options
22