Setup and Connections
15
4
Enter the WEP key printed on the sticker of
the Base Station and then click [Connect].
Before you register your computer with the Base
Station and display video on the computer, you
need to install LocationFree Player on the
computer (1 page 32).
1
With the Base Station powered on, press the
[SETUP MODE] button on the rear panel of
the Base Station. Keep pressing until the
SETUP MODE LED starts blinking.
The SETUP MODE LED blinks.
z Tip
When using a router to connect to the Base
Station, it takes a while for the IP address to be
assigned to the Base Station by DHCP. The Base
Station does not appear in the window shown in
Step 2 until the IP address has been assigned.
Proceed to Step 2 after the NETWORK LED
turns on.
STEP 1-3
Display Video on your
LocationFree device
SETUP MODE
LED