trusted-port
Interfaces :
Te 1/1
Dell#
Related
Commands
• ipv6 nd ra-guard enable — Allows you to configure the RA guard related
commands.
• ipv6 nd ra-guard policy — Defines the RA guard policy name and enter the RA
guard policy list configuration mode.
• device-role — Specifies the role of the device attached to the port.
•
hop-limit — Enables the verification of the advertised hop count limit.
• mtu — Sets the maximum transmission unit (MTU) value.
• other-config-flag — Enables the verification of the advertised other
configuration parameter.
• reachable-time — Sets the advertised reachability time.
• retrans-timer — Sets the advertised retransmission time.
• router-preference maximum — Enables the verification of the advertised default
router preference (DRP) value.
• trusted-port — Applies the policy to trusted ports.
• ipv6 nd raguard attach-policy — Applies the IPv6 RA guard to a specific
interface.
show ipv6 neighbors
Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor
addresses stored on the control processor (CP).
S6000
Syntax
show ipv6 neighbors [vrf vrf-name] [ipv6-address| interface
interface]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to display the neighbors corresponding to that VRF.
NOTE: If you do not specify this option, neighbors
corresponding to the default VRF are displayed.
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
interface
interface
Enter the keyword interface then the interface type and
slot/port or number information:
• For a port channel interface, enter the keywords port-
channel
then a number.
1036
Neighbor Discovery Protocol (NDP)
