NOTE: The service-policy commands are not allowed on a port channel.
The service-policy input policy-map-name command and the
service-class dynamic dot1p command are not allowed simultaneously
on an interface.
Related
Commands
policy-map-input — creates an input policy map.
service-policy output
Apply an output policy map to the selected interface.
S6000
Syntax
service-policy output policy-map-name
To remove the output policy map from the interface, use the no service-
policy output
policy-map-name command.
Parameters
policy-map-
name
Enter the name for the policy map in character format (32
characters maximum). You can identify an existing policy
map or name one that does not yet exist.
Defaults none
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
A single policy-map can be attached to one or more interfaces to specify the
service-policy for those interfaces.
Related
Commands
policy-map-output — creates an output policy map.
1272
Quality of Service (QoS)
