22
Interfaces
The commands in this chapter are supported by Dell Networking operating software on the S6000
platform.
This chapter contains the following sections:
• Basic Interface Commands
• Port Channel Commands
This chapter contains the following sections:
• Basic Interface Commands
• Port Channel Commands
• Time Domain Reflectometer (TDR)
• UDP Broadcast
Basic Interface Commands
The following commands are for Physical, Loopback, and Null interfaces.
clear counters
Clear the counters used in the show interfaces commands for all virtual router redundancy protocol
(VRRP) groups, virtual local area networks (VLANs), and physical interfaces, or selected ones.
S6000
Syntax
clear counters [interface] [vrrp [ipv6 {vrid} | learning-limit
| vlan vlan-id]
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/
port or number to clear counters from a specified interface:
• For IPv4 access-group counters, enter the keyword ip.
• For IPv6 access-group counters, enter the keyword ipv6.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For MAC access-group counters, enter the keyword mac.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For the management interface on the RPM, enter the
keyword ManagementEthernet then slot/port
664
Interfaces
