Reply to request 5 from 172.31.1.66 0 ms
Reply to request 5 from 172.31.1.87 0 ms
Dell#
Example (IPv6)
Dell#ping 100::1
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 100::1, timeout is 2 seconds:
!!!!!
Success rate is 100.0 percent (5/5), round-trip min/avg/max =
0/0/0 (ms)
Dell#
reload
Reboot Dell Networking Operating System (OS).
Syntax
reload [conditional nvram-cfg-change]
Parameters
conditional
nvram-cfg-
change
Reload if the condition is true. A configuration change to the
nvram requires a switch reload. To reload the switch, select
nvram-cfg-change.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
9.1(0.0) Added ‘conditional’ parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
If there is a change in the configuration, FTOS prompts you to save the new
configuration. Or you can save your running configuration with the copy
running-config
command. Use the conditional parameter if any configuration
Control and Monitoring
121
