sflow sample-rate (Interface)
Change the interface default sampling rate.
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate
command.
Parameters
value Enter the sampling rate value. For the C-Series and S-Series,
the range is from 256 to 8388608 packets. Enter values in
powers of 2 only; for example, 4096, 8192, 16384, etc. The
default is
32768 packets.
Defaults The Global default sampling.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
This command changes the sampling rate for an interface. By default, the sampling
rate of an interface is set to the same value as the current global default sampling
rate. If the value entered is not a correct power of 2, the command generates an
error message with the previous and next power-of-2 value. Select one of these
two number and re-enter the command.
Related
Commands
sflow sample-rate (Global) — changes the sampling rate globally.
1472
sFlow
