ETS Commands
The following ETS commands are supported on the Dell Networking OS.
dcb-enable
Enable data center bridging.
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues Enter the pfc-queue range. To disable DCB, use the no dcb
enable command. The range is from 1 or 2.
Defaults None
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
Version
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
By default, iSCSI is enabled on the unit and the flow control is enabled on all of the
interfaces. It is also acts as defaults when the link-level flow control is enabled on
one or more interfaces.
Enables priority flow control or enhance transmission selection on interface.
Related
Commands
dcb <ets | pfc> enable — enable priority flow control or enhanced transmission
selection on interface.
clear ets counters
Clear all ETS TLV counters on an interface.
Syntax
clear ets counters port-type slot/port[]
486
Data Center Bridging (DCB)
