Command
History
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.5(0.0) Introduced on the Z9000, S6000, S4810, S4820T, and MXL..
Usage
Information
Use this command to add, edit, or delete an IPv6 RDNSS address and lifetime value.
You can configure up to four IPv6 RDNSS addresses. You must specify a lifetime
using the lifetime or infinite parameter.
Example
Dell(conf-if-te-1/1)#ipv6 nd dns-server 1000::1 1
ipv6 route
Establish a static IPv6 route.
S6000
Syntax
ipv6 route [vrf vrf-name] ipv6-address prefix-length {ipv6-
address | interface | interface ipv6-address} [distance] [tag
value] [permanent] [weight weight-value]
To remove the IPv6 route, use the no ipv6 route [vrf vrf-name]ipv6-
address prefix-length {ipv6-address | interface | interface
ipv6-address} [distance] [tag value] [permanent] [weight]
command.
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the
VRF to install IPv6 routes in that VRF.
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a Null interface, enter the keyword null then the Null
interface number.
IPv6 Basics
823
