A SERVICE OF

logo

Open as PDF
next previous
Dolphin® 9500 Series User’s Guide Rev A
5/15/07
6 - 19
2. In the list, tap on an adapter to review its settings. (Server-assigned IP addresses use DHCP.)
3. If you make a change on one of these tabs, tap OK. The following message appears:
4. You must perform a soft reset to update the registry; see Soft Reset (Warm Boot) on page 2-12. During the soft reset, the
new registry entries created by the changes can be read by the applications that need them.
Do NOT perform a hard reset (see Hard Reset (Cold Boot) on page 2-12) after modifying an adapter here. Hard resets return the
terminal to factory defaults, which means that any network adapter modifications are lost.
!