-------- --------- ---------- ---------- -------
-------- ---------- ---------- ---------------
Configuring IP Addressing
Loopback Interfaces
ProCurve> show ip
Internet (IP) Service
IP Routing : Enabled
Default TTL : 64
ARP Age : 20
VLAN IP Config IP Address Subnet Mask Proxy ARP
DEFAULT_VLAN Manual 10.0.8.121 255.255.0.0 No
VLAN2 Manual 192.168.12.1 255.255.255.0 No
VLAN3 Disabled
Loopback Addresses
Loopback IP Config IP Address Subnet Mask
lo1 Manual 172.16.110.2 255.255.255.255
lo2 Manual 172.16.112.2 255.255.255.255
lo2 Manual 172.16.114.1 255.255.255.255
Figure 8-7. Example of show ip Command Output
Note The default loopback interface (lo0) with IP address 127.0.0.1 is not displayed
in the show ip command output because it is permanently configured on the
switch. To display the default loopback address, enter the show ip route
command as shown in figure 8-8.
8-19
