--------
----------
---- ---------------------------------------- -------- ---------- ----------
Redundancy (Switches 8200zl)
Existing CLI Commands Affected by Redundant Management
Command Action
reload <cr> Boots (warm reboot) the active management module.
Switchover to the standby management module occurs if
redundancy is enabled. If redundancy is disabled or there is no
standby management module, the
reload command boots the
system.
Note: If the running config file is different from the stored config
file, you will be prompted to save the config file. The
reload
at/after
versions of this command do not display a prompt to
save configuration file changes; the changes are lost on the
scheduled reload.
ProCurve(config)# reload
This command will cause a switchover to the other management module
which may not be running the same software image and configurations.
Do you want to continue [y/n]? y
(Boots….)
ProCurve(config)# show redundancy
Settings
Mgmt Redundancy : Enabled
Statistics
Failovers : 1
Last Failover : Mon April 30 09:10:11 2007
Slot Module Description Status SW Version Boot Image
1 ProCurve J9092A Management Module 8200zl Active K.12.XX Primary
2 ProCurve J9092A Management Module 8200zl Standby K.12.XX Primary
Figure 15-25. Example of Reload Command with Redundancy Enabled
15-33
